Magnetic separator suitable work space

February 6, 2012 by rain

The separator gap is the distance between the drum skins and floor pulp on the resulting gap by the effective role of this

gap is the magnetic field region, its thickness can be between 30 ~ 60mm into the

Line adjustment.

2, the precise determination of the working gap in the maintenance, close to the base plate at both ends and put a piece of

plasticine, and then tank fitted, good pads, and then put down the tank to come up with modeling clay to measure its

The squashed thickness that is the exact value of the work space. Rough measurement can be open at both ends of the tank to

put the mine hole, reach out and touch the gap, you can know a rough value. The gap is too large or too small, will shadow

Ring points selected indicators.

3, the appropriate value of the work space according to the production of each plant depending on the method of adjustment is

to subtract four points on the rack supporting the tank gasket. Because the location of the cylinder is fixed, padded

Chip tank increases, the working gap is smaller; reduce gasket, larger work space. The size of the working gap is uniform

along the axial direction should be, if both ends of the gap size, it will cause the slurry flow rate does not

The wide space between the end of the slot body due to low slurry flow rate may produce ore deposition, or even blocked. One

end of the tank blocked the observed phenomenon is to plug the side surface of the drum skin to suck on the

concentrate.author-anyne361

Main nav